NVR Operation – IPC Channel Config
The IPC Channel Config menu is used to Add and Remove individual IP cameras from your NVR.
Reset IPC – Resets the credentials of the selected camera
Search – Search your local area network (LAN) for an IP camera. This will also find cameras that are physically attached to the NVR via Ethernet cable.
Wifi Add – Use this to add your IP cameras to the device after powering them on.
Cable Add – Use this to a wired camera to the NVR.
Add All – Adds all found cameras to the NVR
Delete – Deletes the selected camera from the NVR.
All Delete – Deletes all cameras from the NVR.
Upgrade – Upgrade the firmware of the selected camera.
Wireless Set – Apply the Wireless Settings to the selected camera.
Refresh – Refreshes the list.